Precautions for installing Aba solar street light battery and lamps

April 26, 2021

Precautions for installing Aba Solar Street Light batteries and lamps: Solar street lights are an independent self-powered system. When installing solar-powered maintenance-free batteries, they should be handled gently when placed in the control box to prevent damage to the control box; The connecting wires must be bolted to the terminals of the battery and copper pads to enhance their conductivity. After the output wires are connected to the battery, it is forbidden to short-circuit under any circumstances to avoid damage to the battery and the output line of the battery. It must pass through the PVC threading pipe when it is connected to the controller inside the pole. After completing the above steps, check the wiring of the controller to prevent short circuit. After normal, close the door of the control box.

Installation of solar street light fixtures requires assembly of various parts: the Solar Panel is fixed on the solar panel bracket, the lamp head is fixed to the pick arm, then the bracket and the pick arm are fixed to the main pole, and the connecting line is guided to the control box. (battery box). Before lifting the pole, first check whether the fasteners in each part are firm, whether the lamp is installed correctly, and whether the light source works normally.

Then, if the debugging system works normally, loosen the connection line with the solar panel on the controller, the light source works normally, and the solar panel connection line light is turned off; at the same time, the changes of the indicators on the controller are carefully observed, so the data belongs to Normal, it can be lifted and installed.

When the main pole is hoisted, pay attention to safety precautions. The screws must be fastened. If the component has a deviation from the sun-facing angle, it needs to be adjusted to the south-facing direction.

Put the battery into the battery box, connect the cable to the controller according to the technical requirements, connect the battery first, then connect the load, and then connect the solar panel. When wiring, be sure to pay attention to the wiring and the terminal marked on the controller. If the error is wrong, the positive and negative polarities cannot collide and cannot be reversed, otherwise the controller will be damaged.

Perform the debugging system again to run normally; release the solar panel connection line on the controller, the solar street light source is bright, connect the solar panel connection line, the light goes out; at the same time carefully observe the changes of the indicators on the controller, so the data It is normal to seal the control box.

Author:

Ms. Anny

Phone/WhatsApp:

8618852753718